Alcatel-Lucent OS6450-24 User's Guide download pdf (Page 60)

Mechanical Loading

Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to

uneven mechanical loading.

Circuit Overloading

Consideration should be given to the connection of the equipment to the supply circuit and the effect that

overloading of the circuit might have on overcurrent protection and supply wiring. Appropriate

consideration of equipment nameplate ratings should be used when addressing this concern.

Reliable Earthing

Reliable earthing of rack-mount equipment should be maintained. Particular attention should be given to

supply connections other than direct connections to the branch circuit (e.g. use of power strips).

Table-Mounting OS6450 Switches

General Table-Mounting Guidelines

OmniSwitch 6450 switches can be installed freestanding as tabletop-mounted units. If you will be table-

mounting your switch(es), refer to the important guidelines below before installing.

• When choosing a location for the switch, be sure that adequate clearance has been provided for chassis

airflow and access to the front, back, and sides of the chassis. For recommended clearances, refer to

“Airflow Recommendations” on page 3-2.

• The power cord measures two (2) meters (approximately 6.5 feet) in length. When table mounting the

switch, be sure that the mounting location is within the reach of all the required power sources.

Table-Mounting Installation

1 Locate the four indentations on the bottom of the chassis.

2 Using the adhesive on the rubber feet attach them to the indentations, pressing firmly to ensure they are

properly adhered.

Place the chassis on the table as desired.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 141 142

No comments

Alcatel-Lucent OS6450-24 User's Guide Page 60